| |
In modern masonry
houses the external walls of the house are constructed of two leaves
i.e. an internal concrete blockwork wall and an external brick/block
wall.
A modern timber frame house replaces the internal
leaf of concrete blockwork with an engineer designed structural
timber frame designed strong enough to carry all the load bearings
of the house.
The timber frame is then clad by a traditional
facing material such as brick, render, stone etc. And the internal
walls are insulated and plasterboarded.
|
| |

|
A timber frame house will last as long
as, if not longer, than any other form of construction. Softwood
timber frame houses have been built in increasing numbers
since the 19th century.
Indeed examples of these early designs
can be seen all over Southern England, with many of them being
more than 150 years old.

|
|
| |
No, all houses are built in accordance with
strict Building Regulations with respect to performance in fire.
A BRE (Building Research Establishment) fire safety study concludes
that timber frame is as safe as other forms of construction.
|
| |
Yes, the timber frame structural design is
done by a specialist structural engineer. He provides a full set
of calculations to prove that the timber frame will be more than
capable of supporting loadings and all cladding materials.
The structural timbers of each house are precision
engineered with stress graded timber in line with the structural
engineers calculations to carry the load bearings created by the
roof tiles, floors and cladding.
|
| |
No, Modern timber frame systems have better
acoustic insulation qualities than masonry and fully conform to,
or exceed the current Building Regulations.
|
| |
Generally speaking as long as the basic safety
precautions for DIY activity are followed, there are no special
requirements for timber frame walls. Most objects such as pictures
can be hung on the walls using plasterboard fixings.
Heavier objects such as kitchen cupboards should
be fixed using conventional wood screws, screwed through the plasterboard,
directly onto the timber frame or onto battens.
|
| |
The TFIA (Timber Frame Industry Association)
has asked some of the UK's top lenders/insurers for their opinion
on lending money/insurance for houses using timber frame method.
Some of their quotes are as follows:-
Neil Buckley of Abbey National. "Abbey
National regards modern timber frame construction as being conventional
and there are no restrictions with regard to our lending policy
or procedures".
Patrick Sawdon of Halifax. "Halifax takes
the view that properly constructed timber framed housing with a
suitable external cladding is equally as good as housing which is
built in brick or block and we make no differentiation in the lending
terms offered on either form of construction".
Steve Birt of Association of British Insurers.
"Insurance companies generally draw no distinction between
modern timber frame and brick and block construction in their premium
rate assessment provided the external roof covering is also of tiles,
natural or mineral slates or concrete".
|
| |
Water penetration can arise from internal sources
such as leaking pipes and from external sources as driven rain.
There is a cavity between the structural timber
frame and the external cladding, any rain that is absorbed by the
cladding is unable to penetrate the timber frame and runs down the
cavity and escape through specifically designed weepholes. If rain
is driven across the cavity, the waterproof membrane covering the
timber frame provides complete protection.
Leaking pipes can cause problems with all forms
of construction, but as with all building methods, the independent
BRE (Building Research Company) has undertaken many detailed studies
into the performance of timber frame in the long term. A report
published in 1993 looked at the moisture conditions in the walls
of occupied houses built between 1965 and 1985 and "found no
instances of rot caused by water ingress".
A second report published in 1996 investigated
the record of houses built between 1920 and 1975. This report also
confirmed the results of the earlier study.
|
| |
Bad workmanship can occur on all building sites,
whether the properties being built are timber frame or masonry construction.
With timber frame a larger proportion of the
building is being produced under closely supervised and controlled
factory conditions whenever the panels are being manufactured. These
panels are brought to site and are designed to be put together in
one way only. Therefore a specialist team erect the timber frame
panels on site.

|